Generically Kunckleduster talks about their kits having detailed interiors. That's not quite the case so be sure to read the description of each building, that's where it will tell you if there is interior detail or not. But, I was pretty stoked that these buildings are actually made of wood, 1/8" plywood to be exact! That means that my razor saw technique for creating deep grain is going to work just fine. I'm pretty excited now. Oh and the service was great. Made my order on a Sunday and I think I had it by Wednesday, huge thumbs up on that.
I opted to start with the simplest kit just to get a feel for what's going on with these, so out came the Barbershop. The kit came bagged up with a header indicating a length of 5.25" a width of 4.75" and a Height of 3.5", laser cut and engraved out of 1/8" plywood. Don't discard the header though! The assembly instructions are on the back! They are in fact incredibly simple: " Separate all the parts. Snape the sides to the Front and Back and use wood glue to bond, square building with the base, glue on windows and front porch parts. Do not Glue on Roof or Signs." I pulled out the old Titebond (carpenter's yellow glue) and went to work.
So yes, this is a simple kit and really doesn't need any instructions, however, I think a single sheet with a couple of pictures is still in order. However, assembly is much like the Battle Front and Aetherwork buildings so I didn't have any problems and I pretty much followed my own assembly order. First I scribed the outside wood planks with my razor saw, then attached the window and door frames, using plenty of clamps! By accident I discovered that you really do need to attach the front and back framing pieces first because of the way the walls will fit together. Its a rather clever way to hide the joint and you can see it in the construction pictures. After that it was on to attaching the walls to the base and this one is pretty much finished.
From there I tackled the slant roof. I went ahead and attached the sides to the regular flat roof that came with the barbershop. I'm still not sure if that is right or not because of , but the notch on the flat roof secures it more securely to the building. There is engraved plank detail on the roof, which is a nice touch and the first time I have seen a serious amount of laser engraved detail on a roof.
I think the one thing that I was disappointed with is that the floor on the inside of the building was not engraved, its just the bare plywood. It really wouldn't have taken much to add a floor on the inside. Its the first kit that I have put together that didn't have an engraved floor.
Instructions, such as they are on the back of the header card, gets a 1 out of 5.
Components, I love the components! Plywood is great! I'll still give this a 5 for 5 as far as the components are concerned, however, I was a bit disappointed that the engraved detail didn't go a little farther.
Overall, this is a solid kit, its going to look great on the gaming table and its definitely more than capable of standing up to the punishment that can be given out on the table. So on to the pictures!
Adding the walls to the base
And here up against the Battle Flag Saloon. Pretty good match, they will look fine together after some paint work and weathering. The Knuckleduster door is definitely smaller than the Battle Front door.
I think the Knuckleduster kits are going to look just fine on the streets of Calamity. I have two more from Knuckleduster kits to go. So hopefully some more progress this week.
