Airbrushing Freight Cars with Tru-Scale Paint

When I started this little project I figured I would just fall back on those old stand by railroad paints from Floquil. Well I haven't been paying attention and Testors, who bought Floquil, has discontinued them, in fact discontinued them some time ago. Not knowing much about the railroad paints available now I leaned on somebody that has been more involved than me, Darel from C&Sn3. He recommended Tru-Scale as the best replacement at this point. I went to Caboose Hobbies, who didn't have the color that Darel recommended, and I stood in front of the paint rack for 15 minutes and decided on TCP-139 MOPAC Boxcar Red. I then went looking around for information on how to shoot this paint through an airbrush. This is definitely airbrush paint and a bit on the expensive side at $4.99 for a one ounce bottle. I grabbed all three bottles Caboose had to make sure I had enough and for future additions to the C&N rolling stock roster. After reading up on it that may have been a mistake. Apparently Tru-Scale has a tendency to evaporate out of the bottle, probably because it has an acetone base. Which brings up the fact that this is a solvent based paint and when you shoot it through your airbrush be in a well ventilated area, or a use an airbrush booth and either way wear a mask, and not one of those little sanding masks.

So there is a lot of different information out there and a lot of it is not very informative. In fact I even saw one post that said that Tru-Scale didn't use pigment and that's why it didn't separate. Now that is possible as colors are either built from pigment or dyes, but generally anything called paint uses pigment (inks are dyes). Tru-Scale talks about pigment right on their website. So I combined the information I could find into something that, I hoped, would work for me. This paint is pretty thin already but it wouldn't go through my Infinity airbrush straight from the bottle. I pulled out some little graduated cups that I keep around and measured out three parts paint to one part acetone, that's right acetone as a paint thinner. I got lucky and hit the right combo off the bat and this 3:1 ratio worked like a charm.

Going into the booth were four boxcars, one stockcar, two flatcars, two short cabooses and one combine caboose. The C&N kept all its freight cars and cabooses the same color which means I don't have to switch out colors. Most of the prep consisted of removing trucks and in the case of the cabooses applying a liquid mask to all the windows. The cabooses I completely dissembled and removed the interior lighting components. They are actually quite nicely detailed on the inside, to bad you can't really see it through those small windows.

So two bottles of paint and 10 cars later I was finished, a pretty good days work. The cabooses will probably need some touch up. Its hard getting up underneath some of the overhangs and I found a thumbprint on the side of one so back to the booth for those, probably later this week. With the painting done this bunch is ready to see if these brand new decals I made are going to work. Pretty exciting stuff!

On to the pictures!